Cannawiki

Carbon filter: Difference between revisions

Page Discussion

Carbon filter (view source)

Revision as of 20:14, 9 July 2024

120 bytes removed ,  9 July
New improved models
VisualWikitext
(New improved models)
 
 
This fan is also compatible with the filter below
[[File:385Exploded fandiagram v5V7 fan.png|thumb]]▼
 
==== Parts ====
▲[[File:385 fan v5.png|thumb]]
* 385 Motor
* [[:File:V5V6 385 caseMotor bottomcase.3mf|CaseMotor bottomcase]] (3D printed)
* [[:File:V5 385 case topbottom V7.3mf|Case top]] (3D printed)
* [[:File:V5 385 Motor case.3mf|Case walls]] (3D printed)
* [[:File:Install spacer.3mf|Install spacer]] (3D printed)
* [[:File:V5 385 impeller.3mf|Impeller]] (3D printed)
* [[:File:V5 385 motor mount.3mf|Motor mount]] (3D printed)
* 2.3mm grub screw prop adapter
* 7xx3 M4 bolts
* 4xx2 M4M2.5x3mm nutsbolts
* 12v female barrel jack
 
This will work best with a well-calibrated printer, this design includes a lot of press fits. Some parts may require sanding after printing to fit correctly.
 
1. 3D Print all parts.
 
2. Solder wires onto the 385 motor if it doesn't already have them.
 
3. Insert the motor all the way into the Motor mount. It will be a tight fit.case Feedfeeding the wires through the case and bolt the motor holderback into the case. Bolts should be pointing intothrough the case,slit. addThe thewires nutscan onexit the other sideanyside of the motor mount. Once attached feed the wires back into the case throughfrom the slit.here
 
4. Add the Casecase bottomtop on top of the casemotor assemblyand soscrew farM2.5 Itscrews shouldthrough sitthe flattop andinto bethe flushmotor. withMake sure the topthreaded ofholes on the motor holderare aligned with the case holes. Screw in the 3 M4 bolts to attach the top to the motor case.
 
5. On the sideSeperately, put the prop adapter through the central hole of the impeller and tighten a nut on the other side.
 
6. Put the install spacer around the motor shaft. Then put the impeller onto the shaft on top of the spacer. The spacer will ensure there is clearance between the impeller and case floor. Tighten the grub screws of the prop adapter. This will require an M3 Allen key that is over 60mm long as you will have to reach under the impeller
Retrieved from "https://cannawiki.net/wiki/index.php/Special:MobileDiff/675"