Cannawiki

Carbon filter: Difference between revisions

Page Discussion

Carbon filter (view source)

Revision as of 21:39, 21 February 2024

229 bytes added ,  21 February
m
→‎Parts: link to new files
VisualWikitext
(Change instructions for new models)
m (→‎Parts: link to new files)
== 385 motor Fan (Beta) ==
[[File:385 fan.png|thumb|267x267px]]
This is a centrifugal fan that can be 3D printed and is compatible with the Cannawiki grow controller. A motor driver such as the TB6612FNG is required so that it can be controlled. This fan is designed for the 385 motor to be driven at 12V, but most 385 motors can be run as low as 4.5v5V.
 
This fan is also compatible with the filter below
 
==== Parts ====
[[File:385 fan v5.png|thumb]]▼
 
* 385 Motor
* [[:File:V5 385 case bottom.3mf|Case bottom]] (3D printed)
* [[:File:V5 385 case top.3mf|Case top]] (3D printed)
* [[:File:V5 385 Motor case.3mf|Case walls]] (3D printed)
* [[:File:Install spacer.3mf|Install spacer]] (3D printed)
* [[:File:V5 385 impeller.3mf|Impeller]] (3D printed)
* [[:File:V5 385 motor mount.3mf|Motor holdermount]] (3D printed)
* 2.3mm grub screw prop adapter
* 7x M4 bolts
==== Build steps: ====
This will work best with a well-calibrated printer, this design includes a lot of press fits. Some parts may require sanding after printing to fit correctly.
 
 
 
1. 3D Print all parts
 
3. Insert the motor all the way into the Motor holder. It will be a tight fit. Feed the wires through the case and bolt the motor holder into the case. Once attached feed the wires back into the case through the slit.
 
▲[[File:385 fan v5.png|thumb]]
4. Add the Case bottom on top of the case assembly so far. It should sit flat and be flush with the top of the motor holder. Screw in the 3 M4 bolts
 
15. On the side, put the prop adapter through the central hole of the impeller and tighten a nut on the other side.
 
26. Put the install spacer around the motor shaft. Then put the impeller onto the shaft on top of the spacer. The spacer will ensure there is clearance between the impeller and case floor. Tighten the grub screws of the prop adapter. This will require an M3 Allen key that is over 60mm long as you will have to reach under the impeller▼
 
47. Cover with Case top. This should clip into place and may require some trimming if it does not fit initallyinitially▼
▲2. Put the install spacer around the motor shaft. Then put the impeller onto the shaft on top of the spacer. The spacer will ensure there is clearance between the impeller and case floor. Tighten the grub screws of the prop adapter. This will require an M3 Allen key that is over 60mm long as you will have to reach under the impeller
 
8. Solder barrel jack socket to the wires
▲4. Cover with Case top. This should clip into place and may require some trimming if it does not fit initally
 
The fan can easily be mounted with heavy -duty velcro, thiswhich makes for easy repairs
 
== 120mm PC fan conversion kit ==
Retrieved from "https://cannawiki.net/wiki/index.php/Special:MobileDiff/670"