612
edits
Carbon filter: Difference between revisions
m
→Build steps:: Added coupling image
(→Build steps:: Notes on build steps) |
m (→Build steps:: Added coupling image) |
||
|
This will work best with a well-calibrated printer, this design includes a lot of press fits. Some parts may require sanding after printing to fit correctly.
1. 3D Print all parts[[File:385 fan mid assembly.jpg|thumb]]2. Solder wires onto the 385 motor if it doesn't already have them. (Optionally on the other end solder a 12V barrel jack)▼
3. Insert the motor all the way into the [https://cannawiki.net/wiki/index.php/File:385_Motor_holder.3mf Motor holder] and snap the motor holder into the case walls. It should be a press fit (Optionally add a dab of superglue to the bottom of the motor to help it stay in the motor holder.▼
▲2. Solder wires onto the 385 motor if it doesn't already have them. (Optionally on the other end solder a 12V barrel jack)
▲3. Insert the motor all the way into the [https://cannawiki.net/wiki/index.php/File:385_Motor_holder.3mf Motor holder] and snap the motor holder into the case walls. It should be a press fit (Optionally add a dab of superglue to the bottom of the motor to help it stay in the motor holder.
4. Add the [https://cannawiki.net/wiki/index.php/File:385_case_bottom.stl Case bottom] on top of the case assembly so far. It should sit flat on the [https://cannawiki.net/wiki/index.php/File:385_Case_wall.stl Case walls] and be flush with the top of the motor holder
1. Insert the 5mm * 20mm rod into the shaft coupling and tighten the grub screws to secure. Take care to keep the rod straight.
[[File:Shaft coupling with threaded rod.png|thumb|189x189px|Shaft coupling with threaded rod]]
2. Add the [https://cannawiki.net/wiki/index.php/File:385_fan_blades.3mf Fan blades] onto the thread and tighten the M5 nut to secure them.
| |||